Soft Shell Blocker Transfer
How to Press Soft Shell Blocker
-
Set Temperature and Time
1
-
290F (140C)
-
10 seconds
Load a Test Polyester Garment
2
If possible, slip the platen through the Softshell so there is only one layer of fabric on top. Otherwise lay shirt on top of the platen. Avoid pockets if possible.
Set Pressure
3
-
Manual Press: Tighten dial until the press won’t close. Loosen dial progressively until the press closes, use less pressure for polyester.
-
Hotronix and Geo Knight: 7-8
-
Pneumatic Press: 35-40 PSI
Pre Press: None
4
100% polyester does not hold moisture, so it should not require a prepress unless you just need to smooth out the fabric for 2 seconds.
Place Supacolor
5
Position the transfer on the garment. Lay teflon sheet or parchment paper over the Supacolor.
Press: 8-10 Seconds
6
-
Peel Immediately
7
Hot peel immediately from a corner in one smooth motion. Peel with confidence and without hesitation.
Hold down shirt with your free hand for better control.
Post-Press: 2 Seconds
8
Use a teflon sheet or parchment to seal the edges of the Supacolor.